t60 sensor general error

Epson Stylus Photo 6 Colors Red Blinking Indicator Problem

This is the Epson Stylus Photo Printer General Error Problem light indicator. The paper feed and ink indicator blink together. If you see this problem all you have to do is disassemble and clean  it.

If  this error Appear while printing. All you have to do is turn off the printer and turn on. If it’s still appears double check if their some obstacle blocking inside such as crumpled paper due to paper jam.

The problem is the same to the Following Epson Printer Model

  • Epson Stylus Photo T60
  • Epson Stylus Photo T50
  • Epson Stylus Photo R290
  • Epson Stylus Photo R285
  • Epson Stylus Photo P50

The inkjet printer  indicator status  lights  (hardware)  and status monitor (software)

The ink button and paper blinking simultaneous while the software status monitor indicate General Error



6 comments

  • Anonymous 7 years ago

    Many, thank you very much. The printer has'm fixing this type of General Error. Now I cleaned everything but still appears at power. I've noticed that in the paper feeder, the roller does not rotate, so I'll try unmount and then I'll be back to comment if I could fix it

  • Anonymous 7 years ago

    ok, this is the situation: I found the manager to rotate the roller was dislocated, then put it in place and turned on the printer. It worked a few times and then the source made ​​a small explosion. I opened the source and one of the transistors is burned. The transistor has 5 pins and do not know why it burned. Any idea why it has been burned?

  • aalia lyon 6 years ago

    Our services to Get instance Help , if you have facing any problem about windows 7 ,then please go through this Url its help you.
    windows 7 problems
    Thank you
    Aalia lyon

  • Anonymous 6 years ago

    Hello, I come back to comment that already repaired. I replaced by two pairs of transistors each transistor brings factory.
    That is, each brings transistor 5 pin factory and replaced it with a pair of 3 pin transistors each, but connecting them as in the picture I put here.

    http://www.subirimagenes.net/i/140428072630165907.png

      Be careful in how they are to be welded, as if welded in reverse order will not work or may cause damage to the printer.
    I have Windows XP. Thanks Aalia Lyon for answering 🙂

  • Anonymous 6 years ago

    hai, my printer EPSON Stylus Photo 1390, Blingkin
    but not at same time, alternately

    and, the catridge place, cannpt move, when it off, or even when i just turn in on, it wont move

    should i reset ?

    and, btw, my epson stylus photo, 1390, grey color it turn red, not perfectly grey, even doesnt look like grey, any idea?

    Thanks

  • Anonymous 6 years ago

    you need to reset it using the epson resetter

Comments are closed.